The GSK 980TDi Digital CNC control with absolute encoders uses the GSK GR series drives. This is a dedicated system and will require all new GSK motors, drives and cables to use as a retrofit kit. With this control, we have a wide range of motor sizes to offer. Standard motors include 80 mm, 110 mm, 130 mm, and 175 mm flange motor sizes with up to 30 newton meter power.
GSK is the second largest CNC control builder in the world. They are producing approximately 500 CNC systems per week. This is not a PC based system, but a hardened CNC with the software built directly into the hardware providing maximum reliability.
The modular design of the products allows quick replacement of major components if or when required. GSK provides complete CNC systems which include all required motors, drives, cables, and controls. The GSK 980TDi CNC control with updated software/hardware is a very aggressive full-featured control with 2 ms block processing and programs with G-codes and M-functions. This control uses the GSKLink bus technology, matched with 17-bit absolute encoders that carry out automatic recovery of the system power-on no-block mechanical zero return, servo parameter on-line modification or servo state on-line diagnosis, etc. We are using servo motors and drives on the spindles to perform C-Axis functions. This combination will provide the best performance and number of duty cycles per minute, and will also facilitate the use of live tools.
We offer these components loose so that you can replace your existing motors, drives and CNC control. We can also offer pre-wired kits that include an electrical cabinet for the drives, and a new enclosure for the CNC control. Pricing is based on the number of motors and drives and sizes required.
